Universal-remote-control-urs Universl Remote Manual do Utilizador descarregar pdf (Página 14)

SECTION 2: Auto-Search Method

The Auto-Search Method is a way you can scan through all the

codes in the table to find the right code for your component.

STEP 1: Using your old remote, turn on the component you want

to program with the GAMER... let’s say your TV.

STEP 2: Now, press down on the component button, in this case the

button that says TV, and the SELECT (SEL) button at the same time.

Hold them both down for 3 seconds until the TV component button

LED light turns on.

IMPORTANT: If you don’t press a button within 20 seconds, the

LED light will turn off and exit the set-up mode and you will need

to start over.

STEP 3: Press and release the UP ARROW button. Please note,

each time the Up Arrow is pressed, the code will count up one code

number and send a Power OFF signal. When the correct code is sent

out, the component will turn off.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 111 112

Sem comentários

Universal-remote-control-urs Universl Remote Manual do Utilizador Página 14