Universal-remote-control-urs SR3 Manual do Utilizador descarregar pdf (Página 26)

Page | 25

Channel Control Punch Through

This punch through lets you set up the URC-

SR3 remote so that either the Cable or TV

Channel Controls (CHANNEL UP, DOWN,

LAST, CHANNEL NUMBERS 0-9, +10 and

ENTER) will operate in other component

modes on the remote control.

STEP 1: Press and hold the component

button you want to add channel control to,

such as [DVD], and the SELECT [SEL] button

at the same time for two seconds until the

Component light turns on.

Release the buttons.

STEP 2: Press the CHANNEL UP [CH

] button.

The component LED light will blink once.

NOTE: If you do not press a button within 30

seconds, the component light will turn off.

The remote will exit the programming mode,

and you will have to start over with step one.

STEP 3: Press either the [TV] or CABLE/SAT]

button that you want to use as the source of

channel control. The component light will

blink two times to confirm it is saved.

SELECT

COMPONENT

BUTTONS

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 51 52

Sem comentários

Universal-remote-control-urs SR3 Manual do Utilizador Página 26